Superconducting Qubits
Artificial atoms made of Josephson junctions at 10 millikelvin.
A superconducting qubit is an electrical circuit you could see under a magnifying glass, yet it has discrete energy levels like an atom. Built from capacitors, wires and a Josephson junction, and cooled to about 10 millikelvin, it is the platform behind many of the field's landmark experiments. This lesson builds one from circuit theory up.
What you’ll learn
- Quantize an LC circuit and explain why a harmonic oscillator cannot serve as a qubit.
- Derive from the Josephson relations that a junction is a lossless, nonlinear inductor with energy .
- Write the transmon Hamiltonian, explain the regime, and derive the anharmonicity .
- Describe microwave control, dispersive readout and two-qubit gates, with typical parameters as of the mid-2020s.
An electrical circuit as a quantum oscillator
Start with an LC circuit, a capacitor and an inductor . Its energy, written with the flux through the inductor and the charge on the capacitor, is that of a harmonic oscillator, with playing position and momentum:
For this to behave as a quantum object rather than a lossy classical circuit, two conditions must hold. No dissipation: superconductors such as aluminum, niobium and tantalum carry current without resistance below their critical temperature. No thermal excitation: the level spacing must be much larger than .
A qubit transition is at GHz. At what temperature does ? Answer in millikelvin.
Show the answer
240 mK
K; a handy rule is 1 GHz per 48 mK. At 10 mK the thermal excited population would be . In practice residual populations of order 0.1–1% are seen, because the qubit's effective temperature is set by stray radiation and non-equilibrium effects, not by the refrigerator alone.
The Josephson junction
A Josephson junction is two superconductors separated by a thin insulator, typically aluminum oxide about a nanometer thick, through which Cooper pairs tunnel coherently. It is described by the phase difference between the superconducting condensates on either side, which obeys the two Josephson relations:
Differentiate the first relation and use the second.
The junction acts as an inductor whose inductance depends on the phase, and hence on the current through it: it is nonlinear.
The stored energy. No resistance appears anywhere, so the element is lossless. Replacing by makes the oscillator anharmonic.
Think first According to , what happens to the junction's inductance as the current approaches , and why does that matter?
As , and , so diverges: the junction becomes ever "softer" the harder it is driven. Because the effective inductance changes with the oscillation amplitude, the oscillation frequency depends on the energy, which is exactly what makes the energy levels unequally spaced.
The transmon
Shunt a junction with a capacitor and you get the Cooper-pair-box family of circuits. With the number of Cooper pairs that have tunneled across and the junction phase (), the Hamiltonian is
| Regime | Behavior | |
|---|---|---|
| Cooper-pair box (1999) | strong anharmonicity, but the energy levels depend strongly on : charge noise dephases it within nanoseconds | |
| Transmon (2007) | – | levels nearly independent of ; anharmonicity reduced but still a few hundred MHz |
The trade-off is lopsided in the transmon's favor. Koch et al. (2007) showed that the sensitivity to , the charge dispersion, falls off exponentially, as , while the anharmonicity falls only algebraically. For the phase stays near , and you may expand the cosine:
Small oscillations around the minimum. In this regime can be dropped, because its effect is exponentially small.
A harmonic oscillator at the plasma frequency, .
The quartic term is a perturbation of size about ; to first order only its diagonal elements matter.
The levels are no longer equally spaced.
The anharmonicity is about : typically to MHz, against qubit frequencies of 4–6 GHz. Exact diagonalization gives a somewhat larger magnitude, about at .
To leading order the relative anharmonicity is . For a transmon with , what is , in percent?
Show the answer
5 %
; exact diagonalization gives about 6%. Only a few percent separates the transition from the qubit transition, which is why gates cannot be made arbitrarily fast without leaking into .
Microwave control
A transmon is driven by a microwave voltage coupled capacitively to its island, which adds a term proportional to to the Hamiltonian. Restricted to the two lowest levels, in a frame rotating at the drive frequency , and after the rotating-wave approximation, this becomes
Think first Why not simply make every pulse 1 ns long to beat decoherence?
A short pulse has a broad spectrum, of width roughly . With – MHz, a 1 ns pulse would strongly drive the transition and leak population out of the qubit. Gate times must stay well above (here about 0.5–0.8 ns), and DRAG shaping lets you approach that limit; in practice single-qubit gates take roughly 10–50 ns.
Reading out and keeping coherence
The qubit is read out through a superconducting microwave resonator (frequency , typically 6–8 GHz) coupled to it with strength . When the two are far detuned, , they cannot exchange energy, but the resonator's frequency shifts according to the qubit's state:
Send a weak microwave tone near and look at the phase and amplitude of the transmitted or reflected signal: they differ for and . The measurement is quantum non-demolition: it does not change , so repeating it gives the same answer. The signal is only a few photons, so it is amplified first by a near-quantum-limited Josephson parametric amplifier at millikelvin, then by a cryogenic HEMT amplifier at 4 K. As of the mid-2020s, readout typically takes a few hundred nanoseconds, with assignment fidelities of order 99%.
In dispersive readout, what physical quantity carries the information about the qubit state?
- The photons the qubit emits when it decays
- The state-dependent frequency shift of the resonator, seen as a phase shift of the probe tone
- The voltage across the Josephson junction
- A temperature rise of the chip
Show the answer
B. The state-dependent frequency shift of the resonator, seen as a phase shift of the probe tone
The resonator frequency depends on the qubit state, so a probe tone near acquires a state-dependent phase and amplitude. The qubit does not have to decay for this, which is what makes the measurement quantum non-demolition.
| Loss mechanism | What it is | Mitigation |
|---|---|---|
| Dielectric loss (TLS) | microscopic two-level defects in amorphous oxides at surfaces and interfaces absorb energy | better materials (e.g. tantalum, cleaner interfaces); geometries that store less energy near surfaces |
| Purcell decay | the qubit radiates through its readout resonator into the measurement line | larger detuning; Purcell filters |
| Quasiparticles | broken Cooper pairs, created by stray infrared light or ionizing radiation, tunnel across the junction | shielding and filtering; gap engineering; phonon traps |
| Flux and charge noise | slow frequency fluctuations that dephase the qubit | sweet spots; dynamical decoupling; the transmon's charge insensitivity |
| Thermal photons | residual photons in the readout resonator dephase the qubit | attenuation and filtering of the lines |
Two-qubit gates and the frontier
Neighboring transmons are coupled capacitively, directly or through a coupler, with coupling strengths of a few to tens of MHz. Two families of entangling gates dominate:
- Fixed-frequency qubits, all-microwave gates. The cross-resonance gate drives the control qubit at the target qubit's frequency, producing a conditional rotation.
- Frequency-tunable qubits or couplers. A flux pulse brings into resonance with ; one full oscillation returns with a minus sign, a CZ gate. Tunable couplers switch the interaction on for the gate and off otherwise.
Key takeaways
- An LC circuit quantizes to a harmonic oscillator with ; its equal level spacing makes it useless as a qubit.
- A Josephson junction is a lossless nonlinear inductor with energy ; the transmon, , operates near , where charge dispersion is exponentially suppressed.
- Perturbation theory gives and , a few hundred MHz: enough to address the qubit with shaped 10–50 ns pulses.
- Readout uses the dispersive shift of a resonator, amplified near the quantum limit; entangling gates use cross-resonance or flux-tuned CZ via –.
- Coherence is limited by materials (TLS defects), quasiparticles, Purcell decay and thermal photons, and requires operation near 10 mK.
Check yourself
In the interactive lesson these are scored with your confidence, and what you miss comes back for review.
Why can't a superconducting LC resonator by itself serve as a qubit?
- Its levels are equally spaced, so a drive cannot isolate the transition
- It loses energy too quickly because of resistance
- It cannot be cooled below 1 K
- It has only one energy level
Show the answer
A. Its levels are equally spaced, so a drive cannot isolate the transition
All transitions of a harmonic oscillator have the same frequency, so driving it produces a coherent state rather than a two-level rotation. The Josephson junction's nonlinearity fixes this.
A transmon has MHz and . Which values are closest, using the leading-order formulas?
- GHz and MHz
- GHz and MHz
- GHz and MHz
- GHz and GHz
Show the answer
C. GHz and MHz
GHz GHz, so GHz and . Exact diagonalization gives 4.74 GHz and GHz.
In the two-level approximation, a qubit detuned by GHz from its readout resonator, with coupling MHz, has dispersive shift
- MHz
- MHz
- MHz
- MHz
Show the answer
B. MHz
: MHz. The resonator moves by MHz, comparable to typical resonator linewidths, which is what makes the two states distinguishable.
In a flux-activated CZ gate, which pair of two-transmon states is brought into resonance?
- and
- and
- and
- and (or )
Show the answer
D. and (or )
Tuning so that makes degenerate with . A full oscillation multiplies by , while no other computational state has a partner at that frequency: a conditional phase.
Go deeper
- Transmon Physics · Quantizing a circuit: the Cooper-pair box and the transmon regime.
- Two-Qubit Gates & Tunable Couplers · Cross-resonance, CZ via flux, and coupler designs.
- Dispersive Readout & Cryogenics · Measuring a qubit through a resonator, at millikelvin.
Further reading
- J. Koch et al., "Charge-insensitive qubit design derived from the Cooper pair box", Physical Review A 76, 042319 (2007).
- P. Krantz, M. Kjaergaard, F. Yan, T. P. Orlando, S. Gustavsson & W. D. Oliver, "A quantum engineer's guide to superconducting qubits", Applied Physics Reviews 6, 021318 (2019); arXiv:1904.06560.
- A. Blais, A. L. Grimsmo, S. M. Girvin & A. Wallraff, "Circuit quantum electrodynamics", Reviews of Modern Physics 93, 025005 (2021).