Probabilities from amplitudes, and the post-measurement state.
Every quantum experiment ends with a detector click. The measurement postulate says which clicks are possible, how likely each one is, and what state is left behind. Those three rules drive everything from reading out an algorithm's answer to error correction.
What you’ll learn
State the projective measurement postulate: probabilities ⟨ψ∣Pm∣ψ⟩ and post-measurement states Pm∣ψ⟩/p(m).
Prove that the rule yields a valid, phase-independent and repeatable probability distribution.
Compute probabilities and post-measurement states when only part of a multi-qubit system is measured.
Prove that non-orthogonal states cannot be distinguished with certainty.
Estimate Born probabilities from a finite number of shots, with error bars.
The measurement postulate
A projective measurement is specified by its possible outcomes m and, for each one, a projector Pm onto the subspace of states that "give m". The projectors must be mutually orthogonal and must cover the whole Hilbert space:
Pm†=Pm,PmPn=δmnPm,m∑Pm=I.
The most common case is a measurement in an orthonormal basis{∣m⟩}. Then Pm=∣m⟩⟨m∣, the Born rule reads p(m)=∣⟨m∣ψ⟩∣2, and the state after the measurement is ∣m⟩ (up to a phase).
Projectors of rank greater than one are just as legal. Then outcome m only tells you which subspace the state is in, and the post-measurement state keeps any superposition inside that subspace.
Check your understanding
Continuing the example: you now measure ∣ψb⟩ in the full basis {∣0⟩,∣1⟩,∣2⟩}. What are the outcome probabilities?
31 each
0, 21, 21
Either 0,1,0 or 0,0,1, depending on what the first measurement secretly picked
0, 32, 31
Show the answer
B.0, 21, 21
∣ψb⟩=21(∣1⟩+∣2⟩), so the probabilities are 0, 21, 21. The coarse measurement removed the ∣0⟩ component but did not decide between ∣1⟩ and ∣2⟩.
Why the rule is consistent
The postulate is short, but it must deliver a genuine probability distribution that ignores unobservable phases and agrees with itself when a measurement is repeated. Each property takes one line.
DerivationFour properties in four lines
p(m)=⟨ψ∣Pm∣ψ⟩=⟨ψ∣Pm†Pm∣ψ⟩=∥Pm∣ψ⟩∥2≥0
Positivity. A projector satisfies Pm=Pm†=Pm2.
m∑p(m)=⟨ψ∣(m∑Pm)∣ψ⟩=⟨ψ∣ψ⟩=1
Normalization follows from completeness, ∑mPm=I.
(eiγ∣ψ⟩)†Pm(eiγ∣ψ⟩)=e−iγeiγ⟨ψ∣Pm∣ψ⟩=⟨ψ∣Pm∣ψ⟩
Phase independence. A global phase cancels between bra and ket, so ∣ψ⟩ and eiγ∣ψ⟩ have identical statistics.
Repeatability. An immediate second measurement confirms the first with certainty, because PmPm′Pm=δmm′Pm.
From probabilities to shot counts
You never observe p(m) directly, only frequencies. Repeat a two-outcome measurement on N fresh copies and the number n1 of outcomes 1 is binomially distributed. The estimate p^=n1/N is unbiased, with standard error
sd(p^)=Np(1−p).
The error shrinks only like 1/N: one more decimal digit of precision costs a hundred times more shots.
Predict before you look
You measure a state with p(1)=0.3 a total of N=1000 times. The count of 1s fluctuates around 300. What is its standard deviation?
Show the answer
14.5 counts
The count is binomial with variance Np(1−p)=1000×0.3×0.7=210, so its standard deviation is 210≈14.5. About 95% of runs land within 300±29.
Measuring part of a system
Measuring only qubit 0 of a two-qubit register is a projective measurement with two rank-2 projectors, ∣i⟩⟨i∣⊗I for i∈{0,1}. Write the state as ∣ψ⟩=∑i,jcij∣i⟩∣j⟩.
DerivationPartial measurement
p(i)=⟨ψ∣(∣i⟩⟨i∣⊗I)∣ψ⟩=j∑∣cij∣2
Add up the Born probabilities of every bit string that starts with i.
∣ψi⟩=p(i)(∣i⟩⟨i∣⊗I)∣ψ⟩=∣i⟩⊗p(i)∑jcij∣j⟩
The unmeasured qubit is left in a pure state: the normalized "row i" of the amplitude table cij.
A worked example, which the circuit below lets you test.
One look cannot tell overlapping states apart
Someone hands you either ∣ψ⟩ or ∣ϕ⟩, and you must say which. If ⟨ψ∣ϕ⟩=0, measuring {∣ψ⟩⟨ψ∣,I−∣ψ⟩⟨ψ∣} settles it with certainty. If the two states overlap at all, nothing does.
How well can you do? For two equally likely pure states the optimum is 21(1+1−∣⟨ψ∣ϕ⟩∣2), the Helstrom bound; for ∣0⟩ versus ∣+⟩ it is cos28π≈85%. This is why quantum key distribution works: an eavesdropper facing non-orthogonal signals cannot read them without sometimes getting them wrong, and her errors betray her.
Check your understanding
You receive ∣0⟩ or ∣+⟩ with equal probability. You measure in the Z basis and guess "∣0⟩" on outcome 0, "∣+⟩" on outcome 1. What is your probability of guessing correctly?
21
43
cos28π≈0.854
1
Show the answer
B.43
If the state is ∣0⟩ you always see 0 and guess right. If it is ∣+⟩ you see 1 only half the time. Overall: 21⋅1+21⋅21=43. A measurement in a basis tilted symmetrically between the two states reaches the optimum cos28π.
Questions the postulate leaves open
The postulate tells you how to calculate. It is silent on three deeper questions, and each has its own Rydberg-level lesson.
Think first Is collapse a physical process, or just an update of your knowledge?
The postulate does not say, and no experiment so far has told the readings apart. If ∣ψ⟩ is a state of knowledge, collapse is unremarkable, but you must say whose knowledge and knowledge of what. If ∣ψ⟩ is physical, collapse is a real process that the Schrödinger equation does not contain. That tension is the measurement problem.
Key takeaways
A projective measurement is a complete set of orthogonal projectors {Pm}. Outcome m occurs with probability ⟨ψ∣Pm∣ψ⟩ and leaves the state Pm∣ψ⟩/p(m).
The rule is positive, normalized, phase-independent and repeatable. Projectors of rank greater than one preserve superpositions inside their subspace.
Measuring one subsystem uses Pi⊗I. The rest is left in the normalized conditional state, and local operations elsewhere cannot change the statistics.
Only orthogonal states can be distinguished with certainty; for overlapping states every strategy sometimes fails.
Probabilities are estimated from shots, with standard error p(1−p)/N.
Check yourself
In the interactive lesson these are scored with your confidence, and what you miss comes back for review.
Question 1
For ∣ψ⟩=51(∣0⟩+2i∣1⟩), what is the probability of outcome 1 in the computational basis?
52
54
−54
51
Show the answer
B.54
p(1)=∣⟨1∣ψ⟩∣2=2i/52=54.
Question 2
You measure qubit 0 of 31(∣00⟩+∣01⟩+∣10⟩) and get 0. What was the probability of this outcome, and what is the state afterward?
31; then ∣00⟩
21; then ∣0⟩∣+⟩
32; then ∣0⟩∣+⟩
32; then ∣00⟩ or ∣01⟩ at random
Show the answer
C.32; then ∣0⟩∣+⟩
p(0)=∣c00∣2+∣c01∣2=32, and the post-measurement state is (∣00⟩+∣01⟩)/2=∣0⟩∣+⟩. Qubit 1 is left in a superposition, not in a randomly chosen basis state.
Question 3
Which of these is a valid projective measurement on a qubit?
{∣+⟩⟨+∣,∣−⟩⟨−∣}
{∣0⟩⟨0∣,∣+⟩⟨+∣}
{21I,21I}
{∣0⟩⟨0∣,∣1⟩⟨1∣,∣+⟩⟨+∣}
Show the answer
A.{∣+⟩⟨+∣,∣−⟩⟨−∣}
∣+⟩ and ∣−⟩ are orthonormal, so their projectors are orthogonal and sum to I.
Question 4
Which pair of states can be distinguished with certainty by a single measurement?
∣0⟩ and ∣+⟩
∣+⟩ and ∣+i⟩
∣0⟩ and eiπ/3∣0⟩
∣+i⟩ and ∣−i⟩
Show the answer
D.∣+i⟩ and ∣−i⟩
⟨+i∣−i⟩=0: the states are orthogonal, so a Y-basis measurement tells them apart every time.